The Ecotech Fuelmag™ unit is not a filter. Its function is to change the microbiological material causing blockages in fuel systems and damage to injector equipment.
To achieve this the Ecotech Fuelmag™ unit should be installed where convenient between the fuel supply tank and the filter units.
There is no restriction to flow through the Ecotech Fuelmag™ unit. However heavy infestation can, as they sometimes do in pipes, cause blockages. The Ecotech Fuelmag™ is designed to prevent the build up of foreign matter within the unit. In order to get the best results the unit should be mounted either horizontally or vertically with the fuel connections at the lowest level.
The unique design of Ecotech Fuelmag™ means there is no dedicated inlet or outlet. Connections can be made at either side.
The installation instructions are:
- Install in the fuel line using suitable size tails or threaded unions.
- Either horizontally or vertically.
- Fuel inlet at either side.
- Fuel connections at the lowest level as mounted.
- Bleed air from the unit.
- Finally check the unit and joints for leaks.
To deal with blockages.
Blocking of the Ecotech Fuelmag™ is unlikely but may occur if the fuel tank is heavily contaminated prior to fitting the unit. The clearing of any blockage is dealt with exactly the same as for a blocked pipe. Disconnect from the fuel supply and the filter, pressurise the pipe from the filter end, blowing the blocking material into a suitable container.
|
Ecotech Fuelmag™ Diesel conditioner 
Engine Protection System 
